 |
|
| |
| |
Now we will add some light to this necklace pendent. We will start by bending the wire leads around the LED its self. It is very important with the tolerances we are working with to have a very tight bend with sharp corners. This may require a little practice. |
| |
Next we will insert the led in the hole for it with the graphic face down on the workbench. |
|
Next we place the middle layer on top of the front layer and line it up with the screw holes. Using a fingernail or some pliers bend the long lead up tightly to the battery receptacle and trim it to the same height as the second layer. |
|
Next insert the battery into the space for it. You will need to lightly press to snap it into place and insure a good connection. The led will now light up |
|
Using two of the over priced home improvement store screws fasten the back place tightly. Be careful not to over tighten as acrylic likes to crack... to replace the battery just remove one screw and slide the cover open. |
|
|
|
|
